This publication is intended to provide basic information needed to design effective and energy efficient air systems.In those cases where the system handles a gas other than air, the design data must be modified to allow for the different physical properties of the gas being used.


Armin Hauer on 2020-10-20 00:51:00

Section/Figure/Table No.: Chart E.1 - Air Density Correction Factor (SI)

Type of Comment: Editorial

Comment (justification):
Replace IP density value and unit with value and unit

Proposed Change:
(Multiply Standard Air Density, 1.20 kg/m^3....rather than ... (Multiply Standard Air Density, 0.075 lbm/ft3 × the Factor to obtain Density at Condition B.)

Submit your comments: